Network Management

last person joined: yesterday 

Keep an informative eye on your network with HPE Aruba Networking network management solutions
Back to discussions
Expand all | Collapse all

POE power values

This thread has been viewed 1 times

  • 1.  POE power values

    Posted Apr 28, 2016 02:57 PM

    Using command line from a controller is there a way to get "all" Access Point POE power values?



  • 2.  RE: POE power values

    Posted Apr 28, 2016 11:53 PM

    I've done this before through the use of Aruba AirRecorder - available through Aruba Support Site. I've included links to previous discussions concerning this. Depending on population of APs, I would utilize the "delay" command switch that jgoff recommended previously in the below discussions.

     

    #AirheadsMobile