Network Management

Reply
Occasional Contributor II
Posts: 12
Registered: ‎02-13-2016

While we contain a Rogue AP on the Airwave same is not contained in the Cisco Controller

While we contain a Rogue AP on the Airwave it also gets Manually Contained on the Aruba Controller but in case a Rogue is learnt through a Cisco Controller and same is reflected on the Airwave. But if we contain it in Airwave it does not auto contain on the Cisco Controllers, we have to manually contain on the Cisco Device by logging to it separately. Does it require any additional settings on the AIRWAVE to push containment to Cisco Controllers.

Guru Elite
Posts: 19,983
Registered: ‎03-29-2007

Re: While we contain a Rogue AP on the Airwave same is not contained in the Cisco Controller

Please see the "Manage Rogue AP Containment Option" under Rapids here:  http://www.arubanetworks.com/techdocs/AirWave_8_0_Web_Help/UserGuide.htm#AWUserGuide/Chapter6_RAPIDS/Basic_Configuration.htm?Highlight=rogue containment

 

 

Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Validated Reference Design Guides : http://community.arubanetworks.com/t5/Validated-Reference-Design/tkb-p/Aruba-VRDs
Occasional Contributor II
Posts: 12
Registered: ‎02-13-2016

Re: While we contain a Rogue AP on the Airwave same is not contained in the Cisco Controller

Thanks for your reply Colin.

Both containment options are already set as YES but the containment on AIRWAVE does not push to the cisco controllers. I waited for about 15 mins to check if it takes time but it does not work out. Maximum no. of APs to contain a Rogue is set to default 3.

Search Airheads
Showing results for 
Search instead for 
Did you mean: