Remote Networking

Reply
Frequent Contributor I
Posts: 108
Registered: ‎09-26-2008

IPSec UP (Tunnels) does not show

Hi All,

We are using 3.3.2.18-rn-3.1.3.
When we connect RAP-2/5 and even AP61 as RAP, the IPSec UP columns do not show the numbers of RAP devices.
Is it normal?
The SSIDs are running split tunnel. (There's some typo errors on the user guides on split tunnel)

Michael

Which firmware version can we use?
Guru Elite
Posts: 21,269
Registered: ‎03-29-2007

IPSec Tunnels


Hi All,

We are using 3.3.2.18-rn-3.1.3.
When we connect RAP-2/5 and even AP61 as RAP, the IPSec UP columns do not show the numbers of RAP devices.
Is it normal?
The SSIDs are running split tunnel. (There's some typo errors on the user guides on split tunnel)

Michael

Which firmware version can we use?




The Monitoring Screen should reflect a 1 for every RAP device that is currently connected to the controller. If not, please upgrade to the latest code and check it again. The latest code is in 3.3.2.24-rn-3.1.8.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: