Remote Networking

Reply
Occasional Contributor I
Posts: 5
Registered: ‎03-30-2011

RAP5 Wireless LED not working in Backup mode.

I'm running 5.0.3.3 on my controller.
When my RAP5wn loses connection to the controller the 2.4ghz LED goes out even though the AP is advertising my backup SSID's. I'm able to connect and use the SSID's.

Is it supposed to do that? I found it confusing and for quite a while I thought the wireless backup SSID's were not working.

Thanks
Mike
Guru Elite
Posts: 21,027
Registered: ‎03-29-2007

Re: RAP5 Wireless LED not working in Backup mode.

Starting in 6.x that behavior changed to show the LED, whenever an SSID is broadcasted. In 5.x, it only shows when the AP is connected to the controller AND the SSID is broadcasted.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: