Reply
New Contributor
Posts: 1
Registered: ‎03-17-2011

Rap2 dhcp

In short, my issue is this: Any wireless device that connects to my RAP2's can get an address no problem. If I try to hook a PC into ETH1 it will not pull an address. I have created a profile that does not shutdown the port and has the same settings as the wireless as far as VLAN and tunneling. I can't figure out whats going on. Thanks in advance!
Aruba
Posts: 760
Registered: ‎05-31-2007

Rap2 dhcp

I would sniff the port with Wire Shark and see if you see any traffic
there at all.
Search Airheads
Showing results for 
Search instead for 
Did you mean: