Security

last person joined: 18 hours ago 

Forum to discuss Enterprise security using HPE Aruba Networking NAC solutions (ClearPass), Introspect, VIA, 360 Security Exchange, Extensions, and Policy Enforcement Firewall (PEF).
Back to discussions
Expand all | Collapse all

6.3.1.8 show user-table output

This thread has been viewed 1 times

  • 1.  6.3.1.8 show user-table output

    Posted Jul 24, 2014 08:27 AM

    In previous versions, when using the "show user-table" to determine the mac address of a client connected directly to a RAP port, it would either show authenticated or denied, depending on whether the MAC Address was added to the WLAN controller internal DB. RAP AAA profile is configured with the default-mac-auth profile. Came across a situtaion where on 6.3.1.8, the show user-table output doesn't show the client if in a denied state, but will show if in a authenticated state. Had to use the show ap wired stats to obtain the MAC Address.



  • 2.  RE: 6.3.1.8 show user-table output

    EMPLOYEE
    Posted Jul 24, 2014 10:27 AM

    tmarques,

     

    Did the client get an ip address?  If it did not, that could be why it is not in the user table.

     



  • 3.  RE: 6.3.1.8 show user-table output

    Posted Jul 24, 2014 01:44 PM

    It did not, but in the past (when on code 6.1.x.x) I believe I recall that it would show up in the user-table without an IP Address with role "denied".



  • 4.  RE: 6.3.1.8 show user-table output

    MVP
    Posted Jul 24, 2014 03:50 PM

    nope, that must have been the station table..

    No ip, no entry in the user-table.