Security

Reply
Occasional Contributor II
Posts: 17
Registered: ‎05-08-2007

Adding 802.1x to an existing MS IAS Installation

[ Edited ]

Client scenrio:

 

1. One MS Server 2003 IAS

2. Existing Cisco wireless fat client in production

3. Implementing Aruba wireless.

4. Client does not want to interrupt current production.

 

How can we configure multiple remote access policies on a single IAS radius server?

 

All the hits I found on the internet does not seem to work.

Guru Elite
Posts: 19,964
Registered: ‎03-29-2007

Adding 802.1x to an existing MS IAS Installation

[ Edited ]

It should be able to use the same policies just fine.  Just add the Aruba Controller as a radius client and you should be okay.  If you want to be specific, one of the remote access policies can contain a condition for NAS-IP so that you know you are only receiving traffic from a particular device.

 

Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Validated Reference Design Guides : http://community.arubanetworks.com/t5/Validated-Reference-Design/tkb-p/Aruba-VRDs
Contributor II
Posts: 52
Registered: ‎03-07-2011

Re: Adding 802.1x to an existing MS IAS Installation

Confirming cjoseph... this is exactly what we've done in the exact same situation.

Search Airheads
Showing results for 
Search instead for 
Did you mean: