Security

last person joined: 21 hours ago 

Forum to discuss Enterprise security using HPE Aruba Networking NAC solutions (ClearPass), Introspect, VIA, 360 Security Exchange, Extensions, and Policy Enforcement Firewall (PEF).
Back to discussions
Expand all | Collapse all

Failed to add static route to CPPM

This thread has been viewed 7 times

  • 1.  Failed to add static route to CPPM

    Posted Jun 02, 2017 04:00 AM

    Hi all,

     

    I have set up CPPM to only use the mgmt port, and forward all traffic to the default gateway by default. Due to some reasons, I now need to forward traffic to a specific server via a different gateway. But no matter how I tried, it's always failed. Below is my current config and the commands I have tried with no success:

     

    1.PNG

     

    2.png

     

    3.PNG

     

    4.PNG

     

    Please take a look and have some advice on what I did wrong.

     

    Thank you,



  • 2.  RE: Failed to add static route to CPPM
    Best Answer

    MVP EXPERT
    Posted Jun 02, 2017 04:39 AM

    Hey, my first concern is that the device is  unable to find eth1? What kind of appliance is this? Is this a VM and has eth1 been attached to the underlying VM, only reason I am asking as I can't see if there is a MAC address assigned to eth1.



  • 3.  RE: Failed to add static route to CPPM

    Posted Jun 02, 2017 05:59 AM

    Thank you so much. That solved my problem :). Yes, my CPPM is an VM and after I connect another virtual network adapter to it, I can now add static route without any problems.

     

    Thanks again for your help.