Security

Is there a trial key license I can use to activate a 5k system until I have the final code ?

You can request an eval key via MyNetworking Portal (https://www.hpe.com/networking/mynetworking), or contact your local Aruba partner or Aruba SE.

When registered and login go to register license and select a ClearPass 90-day eval (Lic-1-ClearPass). That should run for 90 days, and you can replace the key and subscription id when you have your production license.

Make sure you select the CP-VA-5K when deploying your VM.

Thank you, this is very helpful and allow me to more forward with the expansion on my cluster

Thank you, this is very helpful and allow me to more forward with the expansion on my cluster

I've installed two trial licenses on two 5k and they are showing 500 endpoint. Will this be an issue when I install the permanent 5k key ?

If the platform is deployed as 5K during installation, I don't expect any issues. That license shows only 500 is no problem and should change when you change the license to you production key.

As a follow up and to close the loop. I've installed the permanent licenses on the trial nodes and the numbers of licenses have been updated accordingly.

Thanks!

 

Thank you for the details !

Sifus,

 

I'm using CP-SW-EVAL with the sizing of CP-5K and already have my production license activated. is there any issue if i continue using  CP-SW-EVAL? I dont want to do the morph because it asked me to add in another hard disk...

You need to use the correct specs for a 5K or it will not be supported.

yes we are following the requirment in the guideline. it just that using cp eval..right now using 2 hard disk with 20 GB and 1 TB..can we keep on using eval but with the spec of 5 K?

You should morph the VM.

any long term effect if we didnt morph it?

TAC support

one last thing..if we morph it..and ask to add in another scsi 0:2..what is the recommended size...1 TB also?

Please work with TAC on this if it’s a live environment.

Thank you for the details !