Security

Reply
New Contributor
Posts: 1
Registered: ‎02-17-2012

location "Building1.floor1"

How do I set or change the "location" of the running config?  (location "Building1.floor1").  Or just get rid of it all together.

MVP
Posts: 337
Registered: ‎07-26-2011

Re: location "Building1.floor1"

[ Edited ]
If you wish to remove the location then select "remove fqln" when provisioning the AP. if not enter the buildings/floors in visualrf and update accordingly.
ACMA, ACMP
If my post addresses your query, give kudos:)
MVP
Posts: 750
Registered: ‎03-25-2009

Re: location "Building1.floor1"

If you mean the controller location, you can change this through the GUI via:

Configuration > Network-Controller> Look for the controller location setting in here.

 

Via the cli just enter the following command:

configure terminal location "whatever you want here"

Koen (ACMX #351 | ACDX #547 | ACCP)

-- Found something helpful, important, or cool? Click the Kudos Star in a post.
-- Problem Solved? Click "Accept as Solution" in a post.
Search Airheads
Showing results for 
Search instead for 
Did you mean: