Wired Intelligent Edge (Campus Switching and Routing)

Reply
Occasional Contributor II

2930F VSF

Hello Everyone,

I am trying to perform VRF on Aruba 2930F.
However Iam getting the following error.

VSF port failure on link 1 port 1/51: 

Peer port 52 is not VSF enabled


ST1-CMDR: VSF port 1/51 is in error state

----  Bottom of Log : Events Listed = 255  ----

 




Can you provide an solution for the same. Thanks in advance.

Aruba Employee

Re: 2930F VSF

Greetings!

 

What version of software are you running on each 2930F?  Also, is there an existing configuration on the switch you're trying to add to the VSF fabric?



MATTHEW FERN – TECHNICAL MARKETING ENGINEER, WIRED INTELLIGENT EDGE
Aruba, a Hewlett Packard Enterprise company

8000 FOOTHILLS BLVD  |  ROSEVILLE, CA 95747
T: 916.540.1759  |  E: mfern@hpe.com
Occasional Contributor II

Re: 2930F VSF

Hi Mathew,

Thanks for your response.
This is the version WC.16.04.0008
There is no existing configuration on the switches.

Regards,
Haresh Niwate
Occasional Contributor II

Re: 2930F VSF

Hello everyone,

I just performed reset on the second switch using the following commands and later vsf worked as expected.

 

reset system configuration
reload

Regards,
Haresh Niwate

 

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: