Wireless Access

Hello,

 

I am new to Aruba controller configurations. Could someone please assist me to configure a scenario with 2 ISP's. I would like to map these 2 connections to 2 separate SSID's. I understand that it is possible through Policy Based Routing but now really sure how the config should be done. Both ISP's can be direclty connected to the WLC or can have a trunk link carrying these two ISP's in two VLAN's.

 

Thanks in adavcne.

 

 

What version of AOS code are you running ? And what controller ?

Thanks for responding. Here are the information

 

Aruba Operating System Software.
ArubaOS (MODEL: Aruba7030), Version 6.4.3.6
Website: http://www.arubanetworks.com
Copyright (c) 2002-2015, Aruba Networks, Inc.
Compiled on 2015-12-11 at 17:31:07 PST (build 52927) by p4build

ROM: System Bootstrap, Version CPBoot 1.0.2.0 (build 46859)
Built: 2014-10-31 10:14:12
Built by: p4build@re_client_46859

Switch uptime is 2 hours 9 minutes 1 seconds
Reboot Cause: User reboot (Intent:cause:register 78:86:50:60)
Supervisor Card
Processor (XLP208 Rev B0 (Secure Boot) , 1600 MHz) with 3736M bytes of memory.
32K bytes of non-volatile configuration memory.
3872M bytes of Supervisor Card system flash.

For each vlan just make the clients default gateway to be the respective ISP router.

 

Thanks Michael. Right now i am using internal DHCP server of the WLC for the guest SSID's. The 2 ISP connections are connected to the WLC through a trunk port and i have created IP interfaces for them. I am not sure by adding those ISP routers as default gateways to SSID can help me. Please advice.

You would change that in the dhcp configuration for those respective subnets.

 

ip dhcp pool <name>
default-router <gateway-ip>

Let me try this. So do i have to add two default routes in to the controllers routing table as well?

Tried and i am afraid its not a successful one.

Ishan,

What's not working exactly?  Do the clients get an ip address?  Can they ping the default gateway, or at least see an arp entry for it?

Are you able to share the config for the controller?

your configuration should do from both  controller and switch. 

Controller configuration

use /(split tunel mode)

SSID 1 = VLAN 2 , default gateway ISP1 router IP(if local DHCP scope)

SSID 2 = VLAN 3 , default gateway ISP2 router IP(if local DHCP scope)

 

APs should

Switch Configuration 

tag vlan 2 - switch port which connect ISP 1

tag vlan 3 - switch port  which connect ISP 2

use ISP router mange DHCP or same range DHCP scope for each user VLANs