Wireless Access

Reply
Occasional Contributor II

2 SSID's & 2 ISP's

Hello,

 

I am new to Aruba controller configurations. Could someone please assist me to configure a scenario with 2 ISP's. I would like to map these 2 connections to 2 separate SSID's. I understand that it is possible through Policy Based Routing but now really sure how the config should be done. Both ISP's can be direclty connected to the WLC or can have a trunk link carrying these two ISP's in two VLAN's.

 

Thanks in adavcne.

 

 

Re: 2 SSID's

What version of AOS code are you running ? And what controller ?
Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
Occasional Contributor II

Re: 2 SSID's

Thanks for responding. Here are the information

 

Aruba Operating System Software.
ArubaOS (MODEL: Aruba7030), Version 6.4.3.6
Website: http://www.arubanetworks.com
Copyright (c) 2002-2015, Aruba Networks, Inc.
Compiled on 2015-12-11 at 17:31:07 PST (build 52927) by p4build

ROM: System Bootstrap, Version CPBoot 1.0.2.0 (build 46859)
Built: 2014-10-31 10:14:12
Built by: p4build@re_client_46859


Switch uptime is 2 hours 9 minutes 1 seconds
Reboot Cause: User reboot (Intent:cause:register 78:86:50:60)
Supervisor Card
Processor (XLP208 Rev B0 (Secure Boot) , 1600 MHz) with 3736M bytes of memory.
32K bytes of non-volatile configuration memory.
3872M bytes of Supervisor Card system flash.

Re: 2 SSID's

For each vlan just make the clients default gateway to be the respective ISP router.

 


If my post is helpful please give kudos, or mark as solved if it answers your post.

ACCP, ACCX #817, ACMP, ACMX #294
Occasional Contributor II

Re: 2 SSID's

Thanks Michael. Right now i am using internal DHCP server of the WLC for the guest SSID's. The 2 ISP connections are connected to the WLC through a trunk port and i have created IP interfaces for them. I am not sure by adding those ISP routers as default gateways to SSID can help me. Please advice.

Re: 2 SSID's

You would change that in the dhcp configuration for those respective subnets.

 

ip dhcp pool <name>
default-router <gateway-ip>

If my post is helpful please give kudos, or mark as solved if it answers your post.

ACCP, ACCX #817, ACMP, ACMX #294
Occasional Contributor II

Re: 2 SSID's

Let me try this. So do i have to add two default routes in to the controllers routing table as well?
Occasional Contributor II

Re: 2 SSID's

Tried and i am afraid its not a successful one.

Re: 2 SSID's

Ishan,

What's not working exactly?  Do the clients get an ip address?  Can they ping the default gateway, or at least see an arp entry for it?

Are you able to share the config for the controller?


If my post is helpful please give kudos, or mark as solved if it answers your post.

ACCP, ACCX #817, ACMP, ACMX #294
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: