Wireless Access

Reply
Highlighted
Frequent Contributor I

3600 WLAN port-channel configuration

Currently have 2 interfaces assigned to port-channel ID 0. Want to move them to port-channel ID 1. Via the GUI, Configuration > Network > Ports > (Port) select one of the ports and from the LACP Group dropdown change from 0 1 and click apply and receive the following error:

 

GigabitEhternet 1/1 :Error:Port is a member of different port-channel grop

 

From Configuration > Network > Ports > (Port Channel) select ID 0 and deselect port 1 from it and click apply and receive the following error:

 

Pc-0 is controlled by LACP

 

Please advise as the correct manner in which to remove both ports from ID 0 to ID 1.

 

Regards,

Tony Marques 

MVP

Re: 3600 WLAN port-channel configuration

Hi Tony,

 

Have you tried to do it through the CLI?

 

 

conf t
int gi 1/0 (or the Interface you want)
no lacp group

 

int gi 1/0
lacp group 1 mode active


And the same on int 1/1 (or the Interface you want)


Please note that depending on your design you might lose connectivity to your controller.

 

Regards

Borja

Regards,
Borja
ACMX #567 //ACCP//CWNA//CWAP
Aruba Employee

Re: 3600 WLAN port-channel configuration

Hi,

 

Please try the following:

 

Configuration > Network > Ports > (Port)->Select the Port

 

Navigate to LACP parameter & keep the LACP Group option blank.

Apply the changes.

 

Then you can change the group id for the port.

 

Please make sure you have console access to the controller in case you lose access via WebUI/SSH while changing the port mapping.

Frequent Contributor I

Re: 3600 WLAN port-channel configuration

Hi Nitesh,


That worked. Thanks!!!


Regards,

Tony Marques

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: