Wireless Access

Reply
Contributor II
Posts: 70
Registered: ‎05-01-2015

7210 Controller no response

Hi guys,

 

 I met a problem today,my 7210 controller didn't response the command 'show run'.

 

(7210) #show running-config | include "ip route"
Building Configuration...
Module Configuration Manager is busy. Please try later
 
(7210) #show log all 10
 
Jul  6 14:03:45  isakmpd[3587]: PAPI_Send: sendto Configuration Manager failed: Resource temporarily unavailable Message Code 5010 Sequence Num is 15749 
Jul  6 14:03:46  isakmpd[3587]: PAPI_Send: To: 7f000001:8226 Type:0x4 Timed out. 
Jul  6 14:04:01  isakmpd[3587]: PAPI_Send: sendto Configuration Manager failed: Resource temporarily unavailable Message Code 5010 Sequence Num is 15750 
 
And I found someone had the same problem :
 
 
But my IOS have aleady upgraded to 6.4.2.6.
 
Could some tell me how to do ?
Guru Elite
Posts: 20,810
Registered: ‎03-29-2007

Re: 7210 Controller no response

You should probably open a case.  There are quite a few reasons why this could happen..  high cpu maybe?  If so, TAC would need to analyse your setup to know what is causing the high CPU and figure out if it is an existing or new bug.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Contributor II
Posts: 70
Registered: ‎05-01-2015

Re: 7210 Controller no response

I may found the reason which caused my controller kept saying 'Modul is busy'.

I enabled the DPI function.

But is this a bug or something? You can't enable the DPI in the firewall?

Guru Elite
Posts: 8,333
Registered: ‎09-08-2010

Re: 7210 Controller no response

You should definitely be able to use DPI. Please open a TAC case.


Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Search Airheads
Showing results for 
Search instead for 
Did you mean: