Wireless Access

last person joined: 15 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

AMP UCC

This thread has been viewed 3 times

  • 1.  AMP UCC

    Posted Jun 25, 2014 12:22 PM

    I have Vocera clients on a voice SSID. When I make calls, the usernames & call detail appear on my Aruba WLC with version 6.3.1.7, but this data does not show up on AMP version 8.0 (UCC). I listed them as "watched clients". Not sure what else to do. Ideas?



  • 2.  RE: AMP UCC

    EMPLOYEE
    Posted Jun 25, 2014 12:25 PM
    Do you have AMON enabled?

    Also, make sure you have UCC enabled in the AMP setup.


  • 3.  RE: AMP UCC

    Posted Jun 25, 2014 12:30 PM

    Thank you.

     

    I have the following:

     

    Enable UCC Data Collection - (yes)

    Enable AMON Data Collection: - (yes)

     

     



  • 4.  RE: AMP UCC

    EMPLOYEE
    Posted Jun 25, 2014 12:42 PM

    On the controller side, did you run the mgmt-server command to point to Airwave?

     

     



  • 5.  RE: AMP UCC

    Posted Jun 25, 2014 01:07 PM

    Yes, it is pointing and I do see AppRF data, but no voice/username information for my voice clients on AMP. Perhaps I restart thre AMP services or adjust the polling intervals?



  • 6.  RE: AMP UCC
    Best Answer

    Posted Jun 25, 2014 01:52 PM

    You need AOS 6.4 to get this information



  • 7.  RE: AMP UCC

    Posted Jun 25, 2014 01:54 PM

    2014-06-25 13_53_16-ArubaOS_6.4_RN.pdf.png



  • 8.  RE: AMP UCC

    Posted Jun 25, 2014 02:12 PM
    Perfect! Thank you!