Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

AP 105 default configuration remotely

This thread has been viewed 1 times

  • 1.  AP 105 default configuration remotely

    Posted May 16, 2012 05:03 PM

    I am working with a 3400 controller and I have 16 - 105AP's already configured and working fine on it. While doing my ap installation feature from the controller, I accidentally gave two ap's somewhat of the same name. Now I know for sure I can reset the ap to its factory default by physically going to it but is there a way to set that ap back to factory default from the controller?

     

    Also once the name is configured already, is it possible to re-provision an AP and give it a new name.......When I attempt to do so, I get just a blank screen.


    #3400


  • 2.  RE: AP 105 default configuration remotely
    Best Answer

    Posted May 16, 2012 07:55 PM

    Perhaps you can try to re-provision the AP with a new name using the command line interface (using SSH or console to the controller).

     

    The following command can be run to rename the AP:

    (Aruba) #ap-rename wired-mac ?
    <wired-mac>             Rename AP at this MAC address



  • 3.  RE: AP 105 default configuration remotely

    Posted May 17, 2012 12:19 AM

    Thank you much. This is just what I needed and it worked........