Wireless Access

Reply
Occasional Contributor I
Posts: 7
Registered: ‎05-03-2012

AP 105's are unable to be provisioned anymore

Ran into a weird issue where I can't provision my AP105's anymore.  The 105's will still be able to lease network info via dhcp (I can ping our master controller after boot), but ADP appears to fail.  Even if I manually set the master controller IP (and the rest of the network stats), a 'show summary' on the AP after boot shows itself as the master controller.  I've done multiple purgeenv's, saves, factory_resets to no avail.  This happens with all the AP105's I've tested (three).  AP125's work just fine (a factory reset 125 can be seen on the master controller webUI right after boot). 

 

Any ideas?  I'm a bit clueless now..

Guru Elite
Posts: 20,816
Registered: ‎03-29-2007

Re: AP 105's are unable to be provisioned anymore

type "show log system 50" to get an idea of what is going on.

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Aruba Employee
Posts: 7
Registered: ‎03-23-2010

Re: AP 105's are unable to be provisioned anymore

Can you give output of "printenv" from apboot prompt & also boot-log , i.e. console log while AP is booting up?

Occasional Contributor I
Posts: 7
Registered: ‎05-03-2012

Re: AP 105's are unable to be provisioned anymore

"show system log 50" wasn't available from the console.. here's output (I had to snip the IP addresses):

 

Hit <Enter> to stop autoboot: 0
apboot>
apboot> printenv
bootdelay=2
baudrate=9600
autoload=n
boardname=Talisker
servername=aruba-master
bootcmd=boot ap
autostart=yes
bootfile=mips32.ari
ethaddr=d8:c7:c8:ca:f7:c7
stdin=serial
stdout=serial
stderr=serial
ethact=eth0

Environment size: 209/65532 bytes
apboot> boot
Checking image @ 0xbf100000
Invalid image format version: 0xffffffff
Checking image @ 0xbf800000

Image is signed; verifying checksum... passed
Signer Cert OK
Policy Cert OK
RSA signature verified.
ELF file is 32 bit
Loading .text @ 0x80e00000 (4508696 bytes)
Clearing .bss @ 0x8124cc20 (16 bytes)
Loading .data @ 0x8124cc30 (32 bytes)
## Starting application at 0x80e00000 ...
Uncompressing..........................................
?
Aruba Networks
ArubaOS Version 5.0.3.0-1.1.0.1 (build 29974 / label #29974)
Built by p4build@stan on 2011-08-26 at 09:52:58 PDT (gcc version 3.4.3)
CPU Rev: aa
71x CPU
Flash variant: default
Cache parity protection disabled
Using 340.000 MHz high precision timer. cycles_per_jiffy=680000
Memory: 122240k/131072k available (1639k kernel code, 8676k reserved, 716k data, 3740k init, 0k highmem)
available.
detected lzma initramfs
initramfs: LZMA lc=3,lp=0,pb=2,dictSize=8388608,origSize=19740672
LZMA initramfs by Ming-Ching Tiew <mctiew@yahoo.com> .........................................................................................................................................................................................................................
AR7100 GPIOC major 0
wdt: registered with refresh
Enabling Watchdog
Talisker RSSI LED initialization
Creating 1 MTD partitions on "ar7100-nor0":
0x00000000-0x01000000 : "flash"
i2c /dev entries driver
i2c-talisker: using default base 0x18040000
AD7416 driver probing for devices on AR7100 I2C
.
Starting Kernel SHA1 KAT ...Completed Kernel SHA1 KAT
Starting Kernel HMAC-SHA1 KAT ...Completed Kernel HMAC-SHA1 KAT
Starting Kernel DES KAT ...Completed Kernel DES KAT
Starting Kernel AES KAT ...Completed Kernel AES KAT

Domain Name: arubanetworks.com
No panic info available
Testing TPM... Passed
<4>ag7100_mod: module license 'unspecified' taints kernel.
AG7100: Length per segment 512
AG7100: Max segments per packet 4
AG7100: Max tx descriptor count 400
AG7100: Max rx descriptor count 252
AG7100: fifo cfg 3 018001ff
AG7100CHH: Mac address for unit 0
AG7100CHH: d8:c7:c8:ca:f7:c7
ATHRF1: Port 0, Neg Success
ATHRF1: unit 0 phy addr 0 ATHRF1: reg0 0
ag7100_ring_alloc Allocated 4800 at 0x80372000
ag7100_ring_alloc Allocated 3024 at 0x806b2000
AG7100: cfg1 0xf cfg2 0x7014
ATHRF1: Port 0, Neg Success
ATHRF1: unit 0 phy addr 0 ATHRF1: reg0 3100
AG7100: unit 0: phy not up carrier 1
Writing 4
Ethernet uplink not active yet
Ethernet uplink not active yet
Ethernet uplink not active yet
Ethernet uplink not active yet
Ethernet uplink not active yet
AG7100: unit 0 phy is up...RGMii 100Mbps full duplex
AG7100: pll reg 0x18050010: 0x1099 AG7100: cfg_1: 0x1ff0000
AG7100: cfg_2: 0x3ff
AG7100: cfg_3: 0x18001ff
AG7100: cfg_4: 0xffff
AG7100: cfg_5: 0x7ffef
AG7100: done cfg2 0x7115 ifctl 0x10000 miictrl 0x12
Ethernet uplink active. Becoming Mesh Portal
AP xml model 39, num_radios 2 (jiffies 13434)
init_asap_mod: installation:0
radio 0: band 1 ant 0 max_ssid 8
radio 1: band 0 ant 0 max_ssid 8
election init: rand=1c HZ=500
asap_gre_init: ADDED GRE protocol c00b01fc
setting bond0 as bridge child
USB not provisioned
Starting watchdog process...
Getting an IP address...
Dec 31 16:00:27 udhcpc[180]: udhcpc (v0.9.9-pre) started
Dec 31 16:00:27 udhcpc[180]: Sending discover...
Kernel watchdog refresh ended.
Dec 31 16:00:29 udhcpc[180]: Sending discover...
Dec 31 16:00:29 udhcpc[180]: Sending select for <snip>
Dec 31 16:00:29 udhcpc[180]: Lease of <snip> obtained, lease time 1800
Dec 31 16:00:29 udhcpc[180]: DHCP OPT 43 deleted airwave config

<snip> 255.255.255.0 <snip>.1
Starting Webserver
NTP Server not saved in flash... using default
ath_hal: 0.9.17.1 (AR5416, REGOPS_FUNC, PRIVATE_DIAG, WRITE_EEPROM, 11D)
ath_rate_atheros: Copyright (c) 2001-2005 Atheros Communications, Inc, All Rights Reserved
ath_rate_atheros: Aruba Networks Rate Control Algorithm
ath_dfs: Version 2.0.0
Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reserved
ath_dev: Copyright (c) 2001-2007 Atheros Communications, Inc, All Rights Reserved
ath_pci: 0.9.4.5 (Atheros/multi-bss)
wifi0: Base BSSID d8:c7:c8:2f:7c:78, 8 available BSSID(s)
edev->dev_addr=d8:c7:c8:ca:f7:c7
edev->dev_addr=d8:c7:c8:ca:f7:c7
wifi0: AP type AP-105, radio 0, max_bssids 8
wifi0: Atheros 9280: mem=0x10010000, irq=49 hw_base=0xb0010000
ip_time_handler: Got ip and packets on bond0 Started master election 30-0
wifi1: Base BSSID d8:c7:c8:2f:7c:70, 8 available BSSID(s)
edev->dev_addr=d8:c7:c8:ca:f7:c7
edev->dev_addr=d8:c7:c8:ca:f7:c7
wifi1: AP type AP-105, radio 1, max_bssids 8
wifi1: Atheros 9280: mem=0x10000000, irq=48 hw_base=0xb0000000
cat: /tmp/master: No such file or directory
shutting down watchdog process (nanny will restart it)...

<<<<< Welcome to the Access Point >>>>>

process `snmpd' is using obsolete setsockopt SO_BSDCOMPAT
dns domain - arc.nasa.gov
User: i am master now
asap_send_elected_master: sent successfully
vap aruba000 vlan is 0. fwd-mode:0 mesh

User: admin
Password:

d8:c7:c8:ca:f7:c7# show sum

Name :Instant-CA:F7:C7
Domain :US
Address :0.0.0.0
Content Filtering :disable
Terminal Access :disable
Organization :
Airwave Address :0.0.0.0
Airwave Shared Key :
Airwave Config Via :DHCP
Syslog Server :0.0.0.0
Syslog Level :notice
Band :all
Master *: <snip> (IP address of itself)
Master Key :a705173a010f39868c5a881852000f06341b1455e3d91888bd
Elected Time :15m:43s
Mesh :enable
Dynamic Radius Proxy :disable
NTP Server :
Configuration Dirty :disable
Allow New APs :enable
Classification :disable
Wireless Containment :disable
Wired Containment :disable
Rogue Containment :disable
LED Off :disable
Airwave :Not Set Up
Image Server State :success
Image Server Message :Success
New Image Version :6.1.2.3-2.0.0.4_32946
New Image URL :http://s3.amazonaws.com/firmwareupdate.arubanetworks.com/ArubaInstant_Orion_6.1.2.3-2.0.0.4_32946
Factory SSID :instant
Image Sync Via :Master
Client Alerts :0
0 Clients
---------
MAC Name IP Address Network Access Point
--- ---- ---------- ------- ------------
1 Network
---------
Key Name Clients
--- ---- -------
instant instant 0
1 Access Point
--------------
MAC IP Address Name Clients
--- ---------- ---- -------
d8:c7:c8:ca:f7:c7 <snip> d8:c7:c8:ca:f7:c7 0
RADIUS Servers
--------------
Name IP Address Port Key NAS IP Address NAS Identifier
---- ---------- ---- --- -------------- --------------
InternalServer 127.0.0.1 1616 b495737c013086fb940a42b79f1e524f
RTLS Servers
------------
Type IP Address Port Key Frequency
---- ---------- ---- --- ---------
Aeroscout 0.0.0.0 0
Airwave 0.0.0.0 0 0

 

 

I can get output from an AP-125 (which works), if necessary, as well.

Aruba Employee
Posts: 5
Registered: ‎04-11-2007

Re: AP 105's are unable to be provisioned anymore

Looking at the AP bootup logs, I find that this is coming up as an IAP, rather than an regular campus AP. If this is a IAP105 (as compared to AP105), then ADP, master discovery, etc is not expected to work, since the AP acts as a Virtual controller by itself.

 

Can you please confirm that, you were indeed supposed to have an AP105, but ended up with an IAP105?

Occasional Contributor I
Posts: 7
Registered: ‎05-03-2012

Re: AP 105's are unable to be provisioned anymore

oh my lord.  Looks like our vendor sent us a mess of IAP105's instead of AP105's (I didn't even know the "instant" series of APs existed).  Well, that explains it.  Thanks a bunch for your help.  

Occasional Contributor I
Posts: 7
Registered: ‎05-03-2012

Re: AP 105's are unable to be provisioned anymore

Ah, apparently you can change IAPs to function regular via the console.  Looks like I'm good now.  Crisis averted.  Thanks everyone!

Search Airheads
Showing results for 
Search instead for 
Did you mean: