Hello All,
I have a question. I have an issue where I was getting interference issue with few of my APs. I chose of the AP with poor quality then make it a spectrum analysis. That rebooted the ap and AP never come back up.
I beleive the AP does not come back up because of the incorrect group. What is the easiest way of getting the AP up without impacting other APs.
One way, I think I can do this is to re-configure the AP with the appriate group, but doing that would impact the other APs.
2. Is to confure one more and shipped to the club. That requires a lift and tech which will $$$$$$$$ lots of it.
Now since I have two controllers I think it can be done without worrying about the other APs as they would fail over the other controller.
Any ideas will be appriciated.
Thanks
Sam