Wireless Access

Reply
Frequent Contributor II
Posts: 144
Registered: ‎01-21-2015

AP 225 port redundancy

Hi All, To provide port redundancy to AP 225 do I need to configure " gre stripping ip" on ap system profile ? or configuring LACP on AP access switch will we enough . any suggestion will be appreciated.

rana
Guru Elite
Posts: 20,773
Registered: ‎03-29-2007

Re: AP 225 port redundancy

By default, if you plug an AP225 into two POE port, it will boot up on the  the first switch to provide it POE.  It will not draw any power from the second port.  If at any time POE is interrupted to the AP on that  first port, it will reboot and come up on the second port that provides it POE.  You cannot avoid the reboot.

 

LACP and GRE striping are not related to redundancy; they are configured when you want additional throughput.  As a practical matter, due to protocol overhead and contention, there are few instances when the actual wired sustained throughput of an AP225 would approach or even exceed the single gigabit port that it is connected to.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Frequent Contributor II
Posts: 144
Registered: ‎01-21-2015

Re: AP 225 port redundancy

So there is no need to configure lacp on ap uplink access switch to provide redundancy.
Am I right?

Sent from Outlook Mail for Windows 10 phone
rana
Guru Elite
Posts: 20,773
Registered: ‎03-29-2007

Re: AP 225 port redundancy

There is no need, no.

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: