Wireless Access

Reply
Occasional Contributor II

AP 277 Mesh - Point to Point

How do I check the signal quality of the mesh link of 2 Ap277's.   Users are reporting bad performance on the ethernet link on the other side.

Guru Elite

Re: AP 277 Mesh - Point to Point

show ap mesh neighbors ap-name <name of ap>



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II

Re: AP 277 Mesh - Point to Point

An ideal value would be?

Re: AP 277 Mesh - Point to Point

Show ap mesh topology long is also a good command, or look in the controller under Mesh Points and click on the portal and point to get an RSSI value.

 

Anything over 20 should be good, but you may want to provide more information (distance, environment, numbers of wired users on the other side, applications in use, etc). 

Jerrod Howard
Sr. Techical Marketing Engineer
Occasional Contributor II

Re: AP 277 Mesh - Point to Point

2 Poe Powered Axis Cameras are the only two clients... feeding from a hardened switch from the AP eth0 mesh point.  Pretty sure it an allignment issue.  Its about 70 yards apart, same elevation.... 

 

Thanks all.

Re: AP 277 Mesh - Point to Point

what is the output from show ap mesh neighbors and show ap mesh topology long?

Jerrod Howard
Sr. Techical Marketing Engineer
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: