Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

AP 93H problem

This thread has been viewed 0 times

  • 1.  AP 93H problem

    Posted Sep 08, 2013 11:26 PM

    ARUBA AP 93H ,when I reset AP display this

     

    APBoot 1.2.7.4 (build 32721)

    Built: 2012-03-08 at 11:34:00

     

    Model: AP-9x

    CPU:   AR7242 revision: 1

    Clock: 390 MHz, DDR rate: 390 MHz, Bus clock: 195 MHz

    DRAM:  64 MB

    POST1: mem 0 (Mismatch at a0200d34: Expected f5755861 got afbe0048) FAILED!

    Copy:  done

    Flash: 16 MB

    PCI:   scanning bus 0 ...

           dev fn venID devID class  rev    MBAR0    MBAR1    MBAR2    MBAR3

           00  00  168c  002a 00002   01 10000004 00000000 00000000 00000000

    Net:   eth0

    Radio: ar9280#0



  • 2.  RE: AP 93H problem

    Posted Sep 08, 2013 11:31 PM

    I think maybe the mem is faild ,can i do anything,to make it ok



  • 3.  RE: AP 93H problem

    Posted Sep 09, 2013 01:08 AM

    So the AP is not booting up completely?

    If the AP does not boot completely then the only thing you can do is trying to clear os

    if clear os does not sove it and you keep getting that error then there is not too much you can do... just do a RMA...

     

    When an ap does not boot

    I actually just do clear os and if that does not fix it i open a case for a RMA.   Also put where is it hanging... and Aruba support always accept my RMAs rquests

     

    Cheers

    Carlos



  • 4.  RE: AP 93H problem

    Posted Sep 09, 2013 01:31 AM

    thank you

    I clear the os ,but AP also cant boot.

     Image is signed; verifying checksum... failed! 0xa6f0325a    
     
    can i refresh the os


  • 5.  RE: AP 93H problem

    EMPLOYEE
    Posted Sep 09, 2013 07:52 AM

    For issue like this, please open a TAC case.  

     

    Thank you



  • 6.  RE: AP 93H problem

    Posted Sep 09, 2013 09:12 AM

    If image is failing and you already did clear os just open a support case and ask for a RMA

    Told them i already did clear os but im still getting that

    They will grant it... becasue there isnt too much you can do with the AP, remenber the ap is a thin ap  is not complicated it works or it does not work... haha in this case is not working so you need a replacement... and also there arent too manyt things you can do

     

    Cheers

    Carlos