Hi everyone,
Just would like to check if someone has experienced this. I have MC-650 running 6.1.x.x and new AP-215. I upgraded the controller to 6.4.3.9 to accommodate the newer AP. I was able to register the AP to the controller. Since I have more than 4 APs already, I made a trunk from one of the controller port going to a trunk port of a switch:
Controller <-> PoE Switch <-> AP
But in this setup the AP is not able to join back to the controller. Config of the ports joining the controller and PoE Switch is trunk and allow all VLANs.
According to the Data Sheet, the controller supports 16 APs despite 4 PoE ports, so definitely cascading/trunking to a PoE switch should work. I have also read the release notes of 6.4.x but haven't read anything confirming this behavior. Is there a known limitation for MC-650 that requires AP to be directly connected?