Wireless Access

Reply
Super Contributor II
Posts: 354
Registered: ‎09-26-2012

AP converting AM

We have deployed AP105 in an office.  all the system is working perfectly fine.  but sometimes one or two AP's convert to AM may be due to interference.

 

How can we stop this behavior. i mean we dont want AP's to convert themselves in AM. how can we do that.

 

Please also note that we have RFProtech licenses installed in controller

Thanks & Regards
Syed Murad Ali
ACMP ACMA CCNA
MVP
Posts: 1,409
Registered: ‎05-28-2008

Re: AP converting AM

[ Edited ]

Configure your ARM profile and disable:  Mode aware ARM

Mode aware ARM is used to turn of access points where there is too much coverage so that additional APs on the same channel cause less interference. If you are not overdeployed to the point of having interference, you should NOT use mode aware ARM.

Untitled.png

*****************2Plus Wireless Solutions****************************
Aruba Airheads - Powered By community for empower the community
************ Don't Forget to Kudos + me,If i helped you******************
Super Contributor II
Posts: 354
Registered: ‎09-26-2012

Re: AP converting AM

Thank You

Thanks & Regards
Syed Murad Ali
ACMP ACMA CCNA
Search Airheads
Showing results for 
Search instead for 
Did you mean: