Wireless Access

Why would any AP not have any flags under AP Installation? 

 

A regular campus AP will not show any flags unless :

 

 

Is the AP up , are you having issues with the AP ?

Up until about 3 hours ago, it was showing up with a flag of 2. Yes it has stopped broadcasting any SSID's. I cannot reprovision it either. I can ping the AP though.

 

From the command line do the following : show ap database and also show log system all <ap mac address>

 

Can you console into the AP ?

 

 

(usext1wlsco01) #show ap database  | Include ussea            
ussea1wlsap01  NorthAmerica-Tier2-3-B  105      10.139.0.50    Up 27m:25s                64.90.226.168

 

 

The show log system all <ap mac address> does not yield any information.

 

I am not local to the site, so consoling in is not an option right now.

 

 

This command will let you know what SSID is getting broadcast from that particular AP:

 

(controller) #show  ap  bss-table ap-name <apname>

 

 

Can you try pinging the AP from the controller ?

 

 

 

 

It's not broadcasting any SSID's, even though it's in the correct AP Group.

 

 

and yes I can ping the AP from the controller

 

(usext1wlsco01) #ping 10.139.0.50
Press 'q' to abort.
Sending 5, 100-byte ICMP Echos to 10.139.0.50, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 154.319/166.817/182.186 ms

(usext1wlsco01) #

The 2 would indicate that you have CPsec enabled.  Is it enabled in this environment?  Do other APs have the 2 flag?

 

If so, check your CPsec whitelist to see if this AP is listed properly.

This AP is visible in AP installation page of controller??
Use show ap config ap-name <ap-name> to verify its configuration.

Hi.

Did you by any chance change the regulatory domain? (even if you are not getting a reg domain mismatch flag)