HI,
I have an AP on a stick survey that I need to complete with an IAP134. We have a group setup in our company controller that has the settings and VAP profile for broadcasting the SSID.
The problem I am getting in the the specific AP configuration. The IAP134 will just sit there with a flashing power light and will not come up.
Does anyone know why this AP wont come up? Unfortunetly the colleage that set our 105 up is in an airplane right now.
This is the current printenv:
apboot> print
bootdelay=2
baudrate=9600
autoload=n
boardname=Arran
bootcmd=boot ap
autostart=yes
bootfile=armv5te.ari
ethaddr=24:de:c6:c6:0f:18
os_partition=0
num_ipsec_retry=85
name=Survey_134
group=SiteSurveyRAP
gatewayip=10.10.10.1
netmask=255.255.255.0
ipaddr=10.10.10.236
ip6prefix=64
dnsip=10.10.13.12
domainname=our.domain
servername=aruba-master
a_ant_gain=398d218a36cb0ab19ff32af291b811c510787151200014x002
g_ant_gain=398d218a36cb0ab19ff32af291b811c510787151200014x002
ap70_ext_ant=1
a_antenna=0
g_antenna=0
ikepsk=F07B34BA6B05A043A3DCD3B262B123783B0843B4CABACD295BC5A4E1E71D6F82
pappasswd=2C257B8C3937B1A19A3E75169F8922DEFE6C9868ECED18A2
usb_type=0
uplink_vlan=0
auto_prov_id=0
is_rmp_enable=0
remote_ap=1
priority_ethernet=0
priority_cellular=0
cellular_nw_preference=1
usb_power_mode=0
mesh_role=0
installation=0
mesh_sae=0
start_type=warm_start
ethact=eth0
master=10.255.192.2
serverip=10.255.192.2
papuser=RemoteAP
stdin=serial
stdout=serial
stderr=serial