12-13-2013 12:13 PM - last edited on 12-14-2013 04:13 PM by cjoseph
I have an AP on a stick survey that I need to complete with an IAP134. We have a group setup in our company controller that has the settings and VAP profile for broadcasting the SSID.
The problem I am getting in the the specific AP configuration. The IAP134 will just sit there with a flashing power light and will not come up.
Does anyone know why this AP wont come up? Unfortunetly the colleage that set our 105 up is in an airplane right now.
This is the current printenv:
apboot> print bootdelay=2 baudrate=9600 autoload=n boardname=Arran bootcmd=boot ap autostart=yes bootfile=armv5te.ari ethaddr=24:de:c6:c6:0f:18 os_partition=0 num_ipsec_retry=85 name=Survey_134 group=SiteSurveyRAP gatewayip=10.10.10.1 netmask=255.255.255.0 ipaddr=10.10.10.236 ip6prefix=64 dnsip=10.10.13.12 domainname=our.domain servername=aruba-master a_ant_gain=398d218a36cb0ab19ff32af291b811c51078715
1200014x002 g_ant_gain=398d218a36cb0ab19ff32af291b811c51078715 1200014x002 ap70_ext_ant=1 a_antenna=0 g_antenna=0 ikepsk=F07B34BA6B05A043A3DCD3B262B123783B0843B4CAB ACD295BC5A4E1E71D6F82 pappasswd=2C257B8C3937B1A19A3E75169F8922DEFE6C9868 ECED18A2 usb_type=0 uplink_vlan=0 auto_prov_id=0 is_rmp_enable=0 remote_ap=1 priority_ethernet=0 priority_cellular=0 cellular_nw_preference=1 usb_power_mode=0 mesh_role=0 installation=0 mesh_sae=0 start_type=warm_start ethact=eth0 master=10.255.192.2 serverip=10.255.192.2 papuser=RemoteAP stdin=serial stdout=serial stderr=serial
12-13-2013 01:58 PM
You need to connect this IAP back into the network. There is a setting once you get back in that allows the AP to come up without an ethernet connection. I forget where that is...don't have access to an IAP right now. I believe this is what's happening.
Consulting Systems Engineer - ACCX, ACDX, ACMX
If you found my post helpful, please give kudos
12-13-2013 05:50 PM
If you want to set up an IAP for site survey this is how you do it
Product Manager - Aruba Networks