Wireless Access

Reply
Occasional Contributor II
Posts: 18
Registered: ‎07-06-2012

AP105 and Juniper NAC Integration

Hello All,

 

Does anyone have any experience with Aruba AP105's integrating with Juniper Network Access Control appliances?  Basically when plugging in the Aruba AP105 into our access switch we would like it to be recognized by the Juniper NAC appliance and the Juniper NAC appliance to flip the access switchport to the appropriate VLAN.  Is this possible and if so how do we go about getting the AP105 being recognized by the Juniper NAC - is it via a certificate?  Once the Juniper NAC flips the AP105 to the appropriate VLAN the AP will then get an IP address that will allow it to call home to the controller.  Any suggestions?

 

Cheers,


Brian

 

Guru Elite
Posts: 20,759
Registered: ‎03-29-2007

Re: AP105 and Juniper NAC Integration

You probably have to contact Juniper to see what your options are with their NAC appliance..

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 18
Registered: ‎07-06-2012

Re: AP105 and Juniper NAC Integration

OK, I will check with Juniper.  But do you know if these scenarios are possible with the 105's regardless of the vendor?

Guru Elite
Posts: 20,759
Registered: ‎03-29-2007

Re: AP105 and Juniper NAC Integration

You need to speak to Juniper about their capabilities.

 

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: