Wireless Access

Reply
Contributor II

AP135 shuts down eth1 due to insufficient POE voltage [power profile 2]

AP135 is plugged into Cisco 3560x switch and lldp is enabled as well. But it shuts down eth1 port due to insufficient power.

 

Any ideas?

Re: AP135 shuts down eth1 due to insufficient POE voltage [power profile 2]

 

You need 802.11at in order to get power on e1 and the 3560 supports 802.11af instead.

 

 

Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
Aruba

Re: AP135 shuts down eth1 due to insufficient POE voltage [power profile 2]

What code are you running? This behavior has been changing a bit in recent releases.

 

Prior to 6.2, only layer 1 negotiation for 802.3at POE was supported. With 6.2, LLDP can be used to identify an 802.3at source.

 

/Onno Harms, Aruba

/Onno
Contributor II

Re: AP135 shuts down eth1 due to insufficient POE voltage [power profile 2]

@vfabian - 3560X supports POE+

 

The code is 6.1.3.8. This means I need to use a POE injector for the AP?

Aruba

Re: AP135 shuts down eth1 due to insufficient POE voltage [power profile 2]

If you need the second ethernet port, you should either use an 802.3at midspan, or upgrade to 6.2.

/Onno

Re: AP135 shuts down eth1 due to insufficient POE voltage [power profile 2]

missed the "x"

Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
Contributor II

Re: AP135 shuts down eth1 due to insufficient POE voltage [power profile 2]

I also had to upgrade the IOS image on Cisco 3560X to get it working. (12.2 => 15.0)

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: