Wireless Access

Reply
Contributor I

AP225 LACP LMS IP with 6.4.2.x

We have two controllers in a master/standby config with a VRRP ip address.  I am also trying to configure LACP LMS IP information and having trouble.

 

I followed the documentation Aruba has, but the AP-225 Enet1 is still in standby mode.  For the LMS IP information, I used the same LMS IP listed under AP System profile (our VRRP ip) and the Striping IP was +1.  I rebooted the AP225 - it does show the striping IP but Enet1 is still in standby mode. 

Valued Contributor II

Re: AP225 LACP LMS IP with 6.4.2.x

HI,

 

Which controller and which AOS code you are using ?

 

 

Cheers,
Venu Puduchery,
[Is my post helped you ? Give Kudos :) ]
Guru Elite

Re: AP225 LACP LMS IP with 6.4.2.x

Is your switch configured for LAG with LACP for each AP? What does the switch show for LACP status.


Thanks,
Tim

Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Contributor I

Re: AP225 LACP LMS IP with 6.4.2.x

Controllers: 

7210

 

AOS:

6.4.2.4

 

Switch output


LACP

LACP Trunk Port LACP Admin Oper
Port Enabled Group Status Partner Status Key Key
---- ------- ------- ------- ------- ------- ------ ------
A5 Active Trk1 Up Yes Success 0 290
A6 Active Trk1 Up Yes Success 0 290

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: