Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

AP225 Link Aggregation - Step by Step Guide

This thread has been viewed 1 times

  • 1.  AP225 Link Aggregation - Step by Step Guide

    Posted Jan 15, 2015 12:05 PM

    Hi

     

    I have read various articles on how to enable GRE stripping but was hoping that someone could post a guide of how to do it on the GUI.  I am only using 2 x SSID's, Corporate and guest'.  I'm not using VLAN's.

     

    I have a few of related questions:

     

    1). Can you enable GRS stripping on the default AP group?

     

    2). Do I have to set up another AP group and add all AP's to it i.e. 'AP-Group LACP'?

     

    3). Do you set the LMS IP to the same IP address as the controller?

     

    Any screen shots would be much appreciated.

     

    Using 6.4

     

    Thank you in advance

     

    David

     

     


    #AP225


  • 2.  RE: AP225 Link Aggregation - Step by Step Guide

    EMPLOYEE
    Posted Jan 15, 2015 12:13 PM

    You should not use the default AP group.

     

    Take a look here:

     

    http://community.arubanetworks.com/t5/Controller-Based-WLANs/How-to-configure-AP-224-225-to-use-link-aggregation-to-use-both/ta-p/176182

     


    #AP225