Wireless Access

Reply
New Contributor
Posts: 2
Registered: ‎04-25-2016

AP225 aggregated ports - configuration required?

I have a number of AP225 APs being installed without a controller.

 

I have LACP trunk ports setup on HP 2950 POE+ switches however once I connect both Ethernet ports on the AP I lose IP connectivity - I am unable to see where I apply any configuration to configure aggregated ports on the AP for throughput.

 

From what I have read I need to add a LMS IP and GRE STRIPING however this seems to be directed towards a controller?

 

Can someone advise?

Guru Elite
Posts: 8,754
Registered: ‎09-08-2010

Re: AP225 aggregated ports - configuration required?

Did you create a trunk on the switch with LACP enabled?

Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
New Contributor
Posts: 2
Registered: ‎04-25-2016

Re: AP225 aggregated ports - configuration required?

Yes - LACP trunk created on the switch

Search Airheads
Showing results for 
Search instead for 
Did you mean: