03-26-2016 11:29 AM
I have purchased from a company which went bancrupt one APIN0205. I do NOT have a controller, and I want to use it as a standalone AP.
I did a factory reset, the device gets an IP from my DHCP server, and I can ping it, but I cannot enter in.
I made a console cable, and I have control.
I have done the follwoing on the command line for a factory reset:
Now the AP boots up, gets and IP and netmask from my DHCP server and it continues to search for the controller using ADP. After a while, it gives up and reboots.
Does anyone know how to conifgure it on the console level to have the device not to look for the controller? In other words, how can I enter its GUI, without the controller?
I looked in a lot of communities but it was not mentioned anywhere this procedure.
Thanks for replying.
Solved! Go to Solution.
03-26-2016 11:32 AM - edited 03-26-2016 11:34 AM
03-26-2016 11:46 AM
It seems that it is a rebranded Aruba AP205 for Alcatel Lucent (there is a sticker on the front of the AP by Alcatel Lucent).
On the back I see the following:
Aruba Networks, Inc
CMIIT IS: 2014AJ2181
Plus some other technical numbers.
03-26-2016 11:56 AM
So without a controller it is not possible to convert it into a standalone AP?
Is there an emulator or a real software controller to temporary use for converting the AP to standalone?
03-26-2016 11:57 AM