Wireless Access

Reply
Contributor I
Posts: 31
Registered: ‎09-09-2010

Adding Second VRRP Instance causes issues

[ Edited ]

having issues with VRRP on 6.1.2.5 as well, I'm alble to add one VRRP (1) instance without any issues.  As soon as I add a second VRRP (2) instace, VRRP freaks out.. and the second VRRP (2) instace becomes MASTER on both controllers.

 

I have tried with and without authentication.

Guru Elite
Posts: 21,260
Registered: ‎03-29-2007

Re: Adding Second VRRP Instance causes issues


opers13 wrote:

having issues with VRRP on 6.1.2.5 as well, I'm alble to add one VRRP (1) instance without any issues.  As soon as I add a second VRRP (2) instace, VRRP freaks out.. and the second VRRP (2) instace becomes MASTER on both controllers.

 

I have tried with and without authentication.


What is the priority for each instance?  Do you have preempt enabled on either VRRP configuration?  What is your VRRP configuration for both instances?  In addition, use the command "show vrrp statistics" to report on what is seen on both controllers.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

MVP
Posts: 501
Registered: ‎04-03-2007

Re: Adding Second VRRP Instance causes issues

Also, define "freaks out". :-)

 

Realize that if you have "priority 255" set, that controller, no matter what, will try and be the master vrrp member. If both controllers in the VRRP pair are set to 255, they'll compete.

==========
Ryan Holland, ACDX #1 ACMX #1
The Ohio State University
Search Airheads
Showing results for 
Search instead for 
Did you mean: