Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Airplay - Using non-AirGroup image

This thread has been viewed 0 times

  • 1.  Airplay - Using non-AirGroup image

    Posted Jan 09, 2014 05:29 PM

    I have a 650 controller and Airplay been a nightmare for us.

     

    At this time I have it working. However I was constantly getting disconnects and after playing flick this switch and test that setting i beleive I have it working.

     

    SOOO my question/s are :

     

    1. Should I be on airGroup image?

    2. I noticed no Airgroup image past 3.4 is this no longer supported for my controller?
     ( hope not just bought this unit )

     

     

    Thanks in advanced.

     



  • 2.  RE: Airplay - Using non-AirGroup image

    EMPLOYEE
    Posted Jan 09, 2014 05:49 PM

    The last supported AirGroup code train for the 650 controller is 6.1.x. The latest is 6.1.3.6-AirGroup which can be downloaded from the support site (support.arubanetworks.com)



  • 3.  RE: Airplay - Using non-AirGroup image

    Posted Jan 09, 2014 05:52 PM

    Sorry, meant to suggest the  6.1.3.4 is the last one with my controller to download.

    I see a 6.1.3.6 but again not for my controller

     



  • 4.  RE: Airplay - Using non-AirGroup image

    EMPLOYEE
    Posted Jan 09, 2014 08:25 PM

    Hm. I don't see it there either. Can you open a TAC case?