Wireless Access

Reply
Occasional Contributor I

All APs in monitor mode

I have a question in my controller in Air monitor is showing that I have 247 air monitor, but this does not seem right because it is almost the number of APs we have. I was told there was no configuration change and after that show that they are as monitor also shows that APs are access.

What can this be?

 

Regards,

Reinaldo

Guru Elite

Re: All APs in monitor mode

Run show audit-trail on your controller to verify that no configuration change was made. 


Thanks, 
Tim

Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Occasional Contributor I

Re: All APs in monitor mode

Thanks,

 

I'll check...

 

Reinaldo

Occasional Contributor I

Re: All APs in monitor mode

And still did not get the customer to exit the command, but had asked before other commands. I put here simply.
From what I understand the Aps are the band 11g as access and 11th as Monitor. Therefore appear on both lists am I correct?

How to change in order to maintain only the original monitor?

 

#show ap active type air-monitor
Active AP Table
---------------
Name Group IP Address 11g Clients 11g Ch/EIRP/MaxEIRP 11a Clients 11a Ch/EIRP/MaxEIRP AP Type Flags Uptime Outer IP
---- ----- ---------- ----------- ------------------- ----------- ------------------- ------- ----- ------ --------

HC1-AP-9A 04 HOSPITAL1-HC1-CONTROLLER01 10.46.12.69 0 0 AM 125 Aa 29d:5h:21m:32s N/A
HC1-MON-5A 01 MONITOR - HC1 - CONTROLLER-01 10.46.14.70 0 AM 0 AM 125 Aa 29d:5h:17m:29s N/A
HC1-AP-6A 02 HOSPITAL1-HC1-CONTROLLER01 10.46.14.71 0 0 AM 125 Aa 5d:7h:5m:37s N/A

 

#show ap active type access-point

Active AP Table
---------------
Name Group IP Address 11g Clients 11g Ch/EIRP/MaxEIRP 11a Clients 11a Ch/EIRP/MaxEIRP AP Type Flags Uptime Outer IP
---- ----- ---------- ----------- ------------------- ----------- ------------------- ------- ----- ------ --------

HC1-AP-9A 04 HOSPITAL1-HC1-CONTROLLER01 10.46.12.69 3 AP:HT:6/20.5/20.5 0 125 Aa 29d:5h:22m:1s N/A
HC1-AP-6A 02 HOSPITAL1-HC1-CONTROLLER01 10.46.14.71 13 AP:HT:6/20.5/20.5 0 125 Aa 5d:7h:6m:6s N/A

Guru Elite

Re: All APs in monitor mode

Change the radio profile back to ap-mode.

 

You'll want to create a new AP group for your Air Monitor with new radio profiles that are in AM-mode. Then reprovision your AP into the air monitor AP group.


Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: