Hi all
I have MC6000 (firmware 6.2.0.2) controllers and aps AP135. I have SSID using both 2.4 and 5 GHz radios. I want to go "full n" at 5 GHz (so all MCS, MIMO and 40 MHz channels), while at 2.4 GHZ I want all MCS and MIMO but only 20 MHz channels.
I have:
- "High throughput enable (SSID)" and "40 MHz channel usage" both enabled in "High-throughput SSID Profile" for my VirtualAP (because I want 40 MHz at 5GHz, and SSID-profile seems at higher hierarchical level than RF profiles)
- for both "802.11a radio profile" and "802.11g radio profile" I have "High throughput enable (radio)" enabled
- in "High-throughput Radio Profile" for 802.11g radio I have enabled "40 MHz intolerance" (while of course it's disabled for a-radio)
is it correct?
PS
Btw, what is "CSD override" in "High-throughput Radio Profile"? (I have it enabled)
Thanks
Bye
Andrea Barontini