Wireless Access

Reply
Occasional Contributor II
Posts: 11
Registered: ‎12-03-2014

Basic SSID and radio profile setup

How do you make the AP's actually broadcast the SSID you've created?  My AP is up and provisioned and my SSID has been created but the radio LED's on the AP are amber.  I've tried configuring AP specific options for radio profiles in "AP Configuration", but I don't see any change.

 

 

MVP
Posts: 4,228
Registered: ‎07-20-2011

Re: Basic SSID and radio profile setup

Is this an IAP or a campus AP ?

Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
Occasional Contributor II
Posts: 11
Registered: ‎12-03-2014

Re: Basic SSID and radio profile setup

Its actually an IAP I converted to campus.

MVP
Posts: 4,228
Registered: ‎07-20-2011

Re: Basic SSID and radio profile setup

You already have an AP-Group , when you created the Virtual-AP (Assign a valid AP) and SSID-Profile did you added to the AP-Group?

 

is the AP part of that AP-Group ?

 

 

Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
MVP
Posts: 4,228
Registered: ‎07-20-2011

Re: Basic SSID and radio profile setup

Also is the Virtual AP / SSID Profile enabled ?
Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
Occasional Contributor II
Posts: 11
Registered: ‎12-03-2014

Re: Basic SSID and radio profile setup

The AP is just in the default AP group.  And yes, according the advanced tab on the virtual ap - SSID page, the box is checked for "Enabled"

MVP
Posts: 4,228
Registered: ‎07-20-2011

Re: Basic SSID and radio profile setup

Can you run the following command :
show ap essid

Also is the SSID hidden by any chance ?

What type of authentication are you using ?
Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
MVP
Posts: 4,228
Registered: ‎07-20-2011

Re: Basic SSID and radio profile setup

if you have a master-local setup make sure you save the config so it can get pushed to the local
Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
Occasional Contributor II
Posts: 11
Registered: ‎12-03-2014

Re: Basic SSID and radio profile setup

Since this was my first go round with the equipment I decided to just use the wizard to create this first WLAN.  In step 3 it asks if you want to broadcast this SSID and I've set that to "Yes". 

 

Its set to a basic WPA2 encryption with psk.  I've set it so its bridged (locally switched) and set the proper vlan tag for it.  But nothing is being broadcast.

Occasional Contributor II
Posts: 11
Registered: ‎12-03-2014

Re: Basic SSID and radio profile setup

I only have the one controller, its current mode is Master.

Search Airheads
Showing results for 
Search instead for 
Did you mean: