Wireless Access

Reply
Contributor I
Posts: 32
Registered: ‎04-29-2009

Broadcast filter ARP and all

Has anyone run into issues with broadcast filter ARP and all?  We just upgraded from 3.4.0.4 to 5.0.4.0 and ran into all kinds of issues with WOW connectivity and broadcast.  WOW's would never get an IP address.  We never had broadcast filter ARP or all on before the upgrade but now it's on 3 of 4 SSID's.  The WOW's would not work until broadcast filter ARP was turned on.  I think it was VoIP proxy ARP before version 3.3.  Also, I'm seeing broadcast from some APS and not from others. 

 

No other changes were made except for the upgrade.  No increase or decrease of clients and the issues were immediately after the upgrade.  Within an hour of turning broadcast filter ARP on, all of issues went away.

 

We have around 1200 AP,s,8 6000 controllers, and 3000 clients.  APS are a mix of AP 70's and AP 125's.

Guru Elite
Posts: 20,811
Registered: ‎03-29-2007

Re: Broadcast filter ARP and all

What is the role that the user gets when the device connects?

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Contributor I
Posts: 32
Registered: ‎04-29-2009

Re: Broadcast filter ARP and all

They put into the logon role.

Contributor I
Posts: 32
Registered: ‎04-29-2009

Re: Broadcast filter ARP and all

They are put into the logon role is what I meant.

Guru Elite
Posts: 20,811
Registered: ‎03-29-2007

Re: Broadcast filter ARP and all

I have never seen that.  Maybe someone can comment on that.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: