Wireless Access

Reply
New Contributor
Posts: 3
Registered: ‎03-06-2012

CLI command to check APs ports

Hi Folks, 

 

We have a third party installing APs for us, unforunately sometimes they connect the AP to the wrong interface. What is the CLI command to check if the AP is connected to ent0 or ent1?  

 

Cheers,

Aruba Employee
Posts: 664
Registered: ‎04-15-2009

Re: CLI command to check APs ports

"show ap debug system-status ap-name ". Go all the way to the bottom and you will see en0 and en1 and the connection status.
Occasional Contributor II
Posts: 36
Registered: ‎02-08-2011

Re: CLI command to check APs ports

I like:

 

show ap details ap-name <ap-name>

 

You can see all of the physical addresses near the beginning of the output. Then I just look at the switchport for which MAC it sees. 

 

I'm not sure what the switch would see if you had a device connected to the other interface at the same time though!

 

Dave

Search Airheads
Showing results for 
Search instead for 
Did you mean: