Wireless Access

Reply
Contributor I
Posts: 39
Registered: ‎02-26-2015

Can AP-225 be configured to register to a primary and a backup controller?


Can AP-225 be configured to register to a primary and a backup controller? Our aim is to have the Aruba AP's register to one controller and in case that fails have it register to a different controller.

Both these controllers would be on a different modeland could be on a different software code also.

 

Any suggestion?

 

thanks,

N.

 

Guru Elite
Posts: 21,490
Registered: ‎03-29-2007

Re: Can AP-225 be configured to register to a primary and a backup controller?

You cannot have an access point fail over to controllers with different versions of code, no.  The problem is that the access point either upgrades or downgrades to the code of the controller that it attempt to connect to, if the code does not match.  That creates an outage and a boot loop and is not supported.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: