Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Can't move AP out of default group using MM

This thread has been viewed 8 times

  • 1.  Can't move AP out of default group using MM

    Posted Mar 08, 2018 04:49 PM

    I built a fancy new AP group using my new single band SSIDs...  I provision my AP to use the new group,  the AP reboots and goes right back in to the default group.  Tips?



  • 2.  RE: Can't move AP out of default group using MM

    Posted Mar 08, 2018 04:54 PM
    Did you assign an AP system profile under the AP-Group with the LMS IP ?



    Thank you

    Victor Fabian

    Pardon typos sent from Mobile


  • 3.  RE: Can't move AP out of default group using MM

    Posted Mar 08, 2018 05:54 PM

    I went under campus APs, selected the AP changed the group and left the IP the same.

     

    Looks like I can make changes under whitelist as well.



  • 4.  RE: Can't move AP out of default group using MM

    Posted Mar 08, 2018 06:35 PM

    Looks like I had to change it in the whitelist and then provision it for the new group



  • 5.  RE: Can't move AP out of default group using MM

    Posted Mar 09, 2018 02:03 AM
    @WiFivomFranManwrote:

    I built a fancy new AP group using my new single band SSIDs...  I provision my AP to use the new group,  the AP reboots and goes right back in to the default group.  Tips?

    I've this problem before, you can check regulation domain and make sure that your RD has support your ap type.