Wireless Access

Reply
Contributor II

Cant see wired user(303H,205h) on my VMC Controller 8.2

Hello friends, is there any visibility for this type of users ?

 

I can't see them on my controller, no matter what port they are connected(e1,e2,e3).

 

 

Guru Elite

Re: Cant see wired user(303H,205h) on my VMC Controller 8.2

You would have to make the port "untrusted" to see them in the user table.  Configuration> AP Groups> Profiles> AP > Ethernet Interface 1 port configuration.  Under General, make sure the Trusted box is unchecked:

 

 

Screenshot 2018-05-11 at 15.59.18.png

After that, you need to go to Configuration> AP Groups> Profiles> AP > Ethernet Interface 1 port configuration> AAA.  You then need to select a AAA profile, because when your port is untrusted, it now becomes subject to some sort of authentication (hence the AAA profile).  Choose a AAA profile that has an initial role of authenticated, otherwise your traffic will be stopped based on whatever is in that initial role:

 

Screenshot 2018-05-11 at 16.03.16.png


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Occasional Contributor I

Re: Cant see wired user(303H,205h) on my VMC Controller 8.2

Ok. But, I how can view the user in the GUI interface. What colluns need actived.

 

By command "show user" in the CLI is Ok:

(ArubaMC-VA) [mynode] #show user
This operation can take a while depending on number of users. Please be patient ....

Users
-----
IP MAC Name Role Age(d:h:m) Auth VPN link AP name Roaming Essid/Bssid/Phy Profile Forward mode Type Host Name User Type
---------- ------------ ------ ---- ---------- ---- -------- ------- ------- --------------- ------- ------------ ---- --------- ---------
172.16.1.12 f0:4d:a2:12:34:56 logon 00:00:02 20:4c:03:12:34:56 Wired 192.168.1.95:0/1 default-open tunnel Win 10 WIRED

 

Guru Elite

Re: Cant see wired user(303H,205h) on my VMC Controller 8.2

If the user did not authenticate on the wired network, there will be no username, just an ip address and a mac address

 

Edit, if the user shows up on the CLI, it should show up in the GUI, as well.


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: