Wireless Access

Reply
Occasional Contributor I
Posts: 5
Registered: ‎07-02-2014

Clients in Bridge Mode not Populating Dashboard

Morning,

 

Last week I migrated our London office onto our mobility controller which is based in the North of England via the corporate WAN. All AP's in London are Campus AP's in Bridge mode, everything is working fine (SSID's, 802.1x etc), however we notice that clients in London do not populate the dashboard clients section with their hostname or IP address, they do however populate the 'monitoring' section, please see below image:

 

Capture.PNG

 

We are currently using image 6.3.1.2

 

Can anyone advise if this is a known issue, or a more fundamental configuration error?

Many thank,

 

Darren

 

Aruba
Posts: 1,368
Registered: ‎12-12-2011

Re: Clients in Bridge Mode not Populating Dashboard

I am not sure if this is fixed in a later patch but we are now on 6.3.1.10.  Could you consider upgrading to try it out?  If not, please open a support case. 

Seth R. Fiermonti
Consulting Systems Engineer - ACCX, ACDX, ACMX
Email: seth@hpe.com
-----
If you found my post helpful, please give kudos
Search Airheads
Showing results for 
Search instead for 
Did you mean: