Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Clients in logon state with HSRP and VRRP IP addresses

This thread has been viewed 0 times

  • 1.  Clients in logon state with HSRP and VRRP IP addresses

    Posted Feb 05, 2013 06:25 AM
      |   view attached

    Hello,

     

    I have two 7210 controllers running ArubsOS 6.2.0.2 connected to two Catalyst 6500 routers via 10GE links.

     

    The Catalysts should act as the Layer 3 gateways in each subnet so I configured the .2 and the .3 IP address in each subnet on their SVI Interfaces. The .1 in each subnet is the HSRP address.

     

    The 7210's have the .6 and .7 in each subnet and the VRRP address is the .5

     

    Ever since I configured this setup I see a list of various IP addresses in the list of clients in the Aruba Web GUI (see attached screenshot). Port 0/0/2 is the physical port on the Aruba 7210 that is connected to the Cisco Catalyst.

     

    Any ideas why I see those IP addresses in the client list?

     

    Thanks for your help!

     

    cheers,

    Harald


    #7210


  • 2.  RE: Clients in logon state with HSRP and VRRP IP addresses
    Best Answer

    EMPLOYEE
    Posted Feb 05, 2013 07:30 AM

    Make sure interface 0/0/2 is trusted.



  • 3.  RE: Clients in logon state with HSRP and VRRP IP addresses

    Posted Feb 05, 2013 08:01 AM

    Hello,

     

    you were right, it had to do with the trust state of the interface. I just have to find out now whether I want that particular interface to be trusted but I know in which direction to look now...

     

    Thanks!

     

    cheers,

    Harald