- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
02-05-2013 03:24 AM
Hello,
I have two 7210 controllers running ArubsOS 6.2.0.2 connected to two Catalyst 6500 routers via 10GE links.
The Catalysts should act as the Layer 3 gateways in each subnet so I configured the .2 and the .3 IP address in each subnet on their SVI Interfaces. The .1 in each subnet is the HSRP address.
The 7210's have the .6 and .7 in each subnet and the VRRP address is the .5
Ever since I configured this setup I see a list of various IP addresses in the list of clients in the Aruba Web GUI (see attached screenshot). Port 0/0/2 is the physical port on the Aruba 7210 that is connected to the Cisco Catalyst.
Any ideas why I see those IP addresses in the client list?
Thanks for your help!
cheers,
Harald
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator
02-05-2013 04:29 AM
Make sure interface 0/0/2 is trusted.
Colin Joseph
Aruba Customer Engineering
Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator
Re: Clients in logon state with HSRP and VRRP IP addresses
Re: Clients in logon state with HSRP and VRRP IP addresses
02-05-2013 05:00 AM
Hello,
you were right, it had to do with the trust state of the interface. I just have to find out now whether I want that particular interface to be trusted but I know in which direction to look now...
Thanks!
cheers,
Harald
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator