Wireless Access

Reply
Occasional Contributor II
Posts: 12
Registered: ‎03-22-2011

Cluster Deployment

Good one

 

I have one doubt about HA environment, is there any way to put stand-alone controllers on Cluster deployment? When I say cluster, it is hot and stand-by for everything, not only for master or local, and just using 2 controllers...

 

tks

Rodrigo

Rodrigo Piovesana
Guru Elite
Posts: 21,007
Registered: ‎03-29-2007

Re: Cluster Deployment

would a master/backup master configuration serve your needs?

 

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 12
Registered: ‎03-22-2011

Re: Cluster Deployment

Joseph

 

when you say "master/backup master configuration", could you send me a link about this?  I understand that only a master controller will be in HA, and what about the local or remote APs that register on local controllers, how this will be handle in a HA environment?

 

tks buddy!

Rodrigo 

Rodrigo Piovesana
Aruba Employee
Posts: 135
Registered: ‎06-18-2007

Re: Cluster Deployment

Take a look at this VRD:

 

http://www.arubanetworks.com/wp-content/uploads/VRD_Aruba-Mobility-Controllers_8.pdf

 

Also take a look at this site for all the VRDs (design guides/reference materials).  These are good info for  understanding the Aruba products.

http://www.arubanetworks.com/technology/reference-design-guides/

 

What Colin referred to is master-backup, where there is a pair of controllers, but only 1 of the controllers will terminate WAPs.  The other will get a copy of the configuration and will not terminate WAPs unless there is a failure of the primary controller.

 

-Mike

Search Airheads
Showing results for 
Search instead for 
Did you mean: