Wireless Access

Reply
Frequent Contributor II
Posts: 193
Registered: ‎11-18-2011

Command to show License

I want CLI commands to do the following from controller :

 

1- check existing license status (  enabled / disabled )

2- check existing license numbers ( how many APs , how many RFP Lic .....)

3- existing number of APs running on this controller 

4- serial number of APs running on this controller

 

Frequent Contributor II
Posts: 114
Registered: ‎12-02-2011

Re: Command to show License

1 - show license verbose

2 - show license limits

3 - show ap active

4 - I'm not sure but I think there is no such command that show the serial numbers.

Frequent Contributor II
Posts: 193
Registered: ‎11-18-2011

Re: Command to show License

i need to know access points ( around 100 )  serials from Comtroller  , i want from CLI ... if not possible i want from GUI ( but ai need all not one by one ) 

Guru Elite
Posts: 20,807
Registered: ‎03-29-2007

Re: Command to show License


Telnet-1 wrote:

I want CLI commands to do the following from controller :

 

1- check existing license status (  enabled / disabled )

2- check existing license numbers ( how many APs , how many RFP Lic .....)

3- existing number of APs running on this controller 

4- serial number of APs running on this controller

 


4.  show ap database long



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

New Contributor
Posts: 1
Registered: ‎09-25-2016

Re: Command to show License

how  I can find the exicting license in aruba controller GUI.

 

 

Guru Elite
Posts: 20,807
Registered: ‎03-29-2007

Re: Command to show License

configuration> Network> Controller> Licenses



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: