Wireless Access

Reply
Contributor II

Configuration sync

Couple weeks ago I had an incident during a cut where the mobility master stopped configuring a port on the local controller. I had to go into disaster-recovery mode and set the port corectly to regain connectivity.

 

Now that everything is connected and settled, the configuration of that port on the Mobility Master doesn't match the config on the controller. Is there  a command I can run to pull configuration in from the local or re-sync everything?

 

*let me know if a solution will disrupt service.

-Joey
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: