Wireless Access

Reply
MVP
Posts: 370
Registered: ‎07-26-2011

Configure IPSEC retries to be 0 via console?

I have an AP105 here which was previous configured as a RAP and used for site surveying. Currently the configuration on the controller has been removed so I cannot plug the AP back into the controller. My issue is that the AP is rebooting every few minutes or so as it cannot contact the master. I know via the controller I can set the IPSEC retries to be 0 but the controller is unusable at the moment.


Can set the ipsec retries 0 (to stop the reboot) via the console connection?

ACMA, ACMP
If my post addresses your query, give kudos:)
MVP
Posts: 370
Registered: ‎07-26-2011

Re: Configure IPSEC retries to be 0 via console?

[ Edited ]

I've spotted this command whilst waiting, will give it a shot

 

setenv num_ipsec_retry 0

 

*EDIT* Looks like this command did the trick :)

ACMA, ACMP
If my post addresses your query, give kudos:)
Search Airheads
Showing results for 
Search instead for 
Did you mean: